Sirius Rocketry - For the Serious Rocketeer!

Moldin' Oldies PNC-70


  • Model: SRMO PNC-70
  • Manufactured by: Moldin Oldies by Sirius Rocketry

Polyurethane Plastic Reproduction Nose Cone for ST-7/BT-20 Tube

Note: This cone semi-hollow cast, meaning the walls are not as thin and it is a little heavier than the original, but not solid cast. You can use a Dremel tool to thin the walls to lighten it if necessary.  Many models benefit from the extra bit of noseweight.

A note about Moldin' Oldies polyurethane castings:

While quite strong, these castings are just a bit "softer" than plastic parts. If sanding is necessary, they do sand beautifully. These parts have all of the detail of the originals but they may not have all of the strength in the shock cord attachment loop, or the loop may have been eliminated from the casting to prevent it being used for shock cord attachment. You may want to consider alternate methods of attaching shock chords and parachutes, just to be safe.

They should be finished with enamel based primers and paints. (Lacquers don't work too well and should probably be avoided.) These parts are also resistant to solvents so typical plastic cement or plastic welder will not work on them. Epoxy (like the Bob Smith epoxy that we offer) is ideal for these parts.

Lists of old kits that used this cone can be found at Scott Hansen's Ye Olde Rocket Shoppe, a fantastic rocket builder's reference!

Add to Cart:

Customers who bought this product also purchased...

Recently Viewed

Copyright © 2018 Sirius Rocketry Online Store
Sirius Interrogator