PNC-51
Polyurethane Plastic Reproduction Nose Cone
Note: This cone is solid cast. The cone can easily be drilled out to lighten it if necessary. A note about Moldin' Oldies polyurethane castings:
While quite strong, these castings are just a bit "softer" than plastic parts. If sanding is necessary, they do sand beautifully. These parts have all of the detail of the originals but they may not have all of the strength in the shock cord attachment loop, or the loop may have been eliminated from the casting to prevent it being used for shock cord attachment. You may want to consider alternate methods of attaching shock chords and parachutes, just to be safe.
They should be finished with enamel based primers and paints. (Lacquers don't work too well and should probably be avoided.) These parts are also resistant to solvents so typical plastic cement or plastic welder will not work on them. Epoxy (like the Bob Smith epoxy that we offer) is ideal for these parts.
Lists of old kits that used this cone can be found at Scott Hansen's Ye Olde Rocket Shoppe, a fantastic rocket builder's reference!
